Rear cover, rear door, and feed assembly CAUTION: The fuser can be hot while the product is in use. Wait for the fuser to cool before working in that area. 1. Remove the following components: ● Tray 2 cassette ● Left cover. See Left cover on page 13 . ● Scanner assembly. See Scanner assembly on page 13 . ● Control panel. See Control panel on page 15 . ● Right cover. See Right cover on page 17 . 2. Open the toner cartridge door and the rear jam access door. 3. At the front of the product, in the Tray 2 cassette cavity, pull down on the green duplex-paper-feed- assembly release tab (callout 1), and then lower the assembly (callout 2).
Figure 1-26 Remove the rear cover, rear door, and feed assembly (1 of 3) 2 1 20 Chapter 1 Removal and replacement ENWW