Figure 2-10. Removing the Top Case Reassembly Notes Note: Installing a New Top Case • Transfer the following items from the old top case to the new one: Touch pad and support. Left hinge support. • Press down on the touch pad support plate while sliding it into place. Make sure the support is held down at its left and right edges. Check the action of the click buttons before installing the top case. • Engage the tab at the front of the top case, then lower the top case onto the bottom case. • It may be easier to plug in the touch pad flex cable while you are lowering the top case onto the bottom case—rather than waiting until after the top case is fully installed.
HP OmniBook 900 Removal and Replacement 2-19 Heatsink crew, M2.5×5mm 12 inch display only Note: On recent units, a HDD bracket is installed in this area. Screw, M2.5×8mm Screw, M2.5×5m 13 dis Screw, 8-Omni 6-Omni Note: D in these Note heat Omn heat m diffe -inch play only Screw, 8-Omni 6-Omni M2×5mm Book 900†, Book 900B Top case : OmniBook 900† sink shown. For the iBook 900B, the sink and mounting r.