Procedure Implementing IPv6 Multicast Configuring PIM Options Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 ipv6 pim spt-threshold infinity [group-list access-list-name] Example: Device(config)# ipv6 pim spt-threshold infinity group-list acc-grp-1 Configures when a PIM leaf switch joins the SPT for the specified groups. Step 4 ipv6 pim accept-register {list access-list | route-map map-name} Example: Device(config)# ipv6 pim accept-register route-map reg-filter Accepts or rejects registers at the RP.
Step 5 interface type number Example: Device(config)# interface GigabitEthernet 1/0/1 Specifies an interface type and number, and places the switch in interface configuration mode. Step 6 ipv6 pim dr-priority value Example: Device(config-if)# ipv6 pim dr-priority 3 Configures the DR priority on a PIM switch. Step 7 ipv6 pim hello-interval seconds Example: Device(config-if)# ipv6 pim hello-interval 45 Configures the frequency of PIM hello messages on an interface. Implementing IPv6 Multicast 17