4.2 Using the Digital LED Operator 4.2 Using the Digital LED Operator Use the LED operator to enter run and stop commands, display data, edit parameters, as well as display fault and alarm information. u Keys, Displays, and LEDs 11 1 5 12 13 10 2 4 15 3 STOP P 14 9 7 8 6 J1000 STOP 1 据据据据据 2 据据据据据据 3 据据据据据 4 据据据据 5 : : : : : 6 据据据 7 据据据据据 8 据据据据据据 9 据据据据据据据 : : : : Risk of electric shock. WARNING 据据据据据据据据据据据据据据据 据据据 Read manual before installing. Wait 5 minutes for capacitor discharge after disconnecting power supply. To conform to requirements, make sure to ground the supply neutral for 400V class.
据据据据据据据据据据据据据据据据据据据据据据据据 据据据据据据据据据据据 5 据据据据据据据据据据据据 据据据据据据据 400V 据据据据据据据据据据据据据据据据据据据据 据据据据据据据据据据据据据据据据据据据据据 据据据据 Table 4.1 Keys and Displays on the LED Operator 54 SIEP C710606 33A OYMC AC Drive – J1000 User Manual No. Display Name Function 1 Data Display Area Displays the frequency reference, parameter number, etc. 2 ESC Key Returns to the previous menu. 3 RESET Key Moves the cursor to the right. Resets the drive to clear a fault situation. 4 RUN Key Starts the drive. 5 Up Arrow Key Scrolls up to select parameter numbers, setting values, etc. 6 Down Arrow Key Scrolls down to select parameter numbers, setting values, etc. 7 STOP STOP Key Stops the drive. Note: Stop priority circuit.
A fast-stop is available by pressing the STOP key when the drive detects a danger even if the drive is running by a signal from the multi- function contact input terminal (REMOTE is set). To avoid stoppage by using the STOP key, set o2-02 (STOP Key Function Selection) to 0 (Disabled). 8 ENTER Key Selects all modes, parameters, settings, etc. Selects a menu item to move from one display screen to the next. 9 LO/RE Selection Key Switches drive control between the operator (LOCAL) and the control circuit terminals (REMOTE). Note: LOCAL/REMOTE key effective during stop in drive mode. 10 RUN Light Lit while the drive is operating the motor.
11 LO/RE Light Lit while the operator (LOCAL) is selected to run the drive.