4.3 The Drive and Programming Modes The Setup Group within the Programming Mode In Setup Group, the user can access the minimum group of parameters required to operate the application. Note: Setup Group parameters are listed in Table 4.4 . Figure 4.5 illustrates the keys to press to enter the Setup Group. In this example, the source of the frequency reference is changed from the control circuit terminals to the LED Operator (i.e., b1-01 is changed from 1 to 0). Frequency reference appears when powered up STOP Press until appears Parameter Display Control Circuit LED Operator Terminal Select digit to edit Parameter Display (2x) Move to the right to change parameter settings.
Scroll down to view and check settings in the Setup Mode. To return to the Top Menu, press . To view or edit other parameters, press and . Figure 4.5 Setup Group Example u Changing Parameter Settings or Values This example explains changing C1-01 (Acceleration Time 1) from 10.0 seconds (default) to 20.0 seconds. Start-Up Programming & Operation 4 10. Press the key until back at the initial display. u Verifying Parameter Changes: Verify Menu The Verify Menu lists edited parameters from the Programming Mode. The Verify Menu helps determine which settings have been changed, and is particularly useful when replacing a drive. If no settings have been changed the Verify Menu will read .
The Verify menu also allows users to access and re-edit edited parameters. Note: The Verify Menu will not display parameters from the A1 group even if those parameters have been changed from default settings. SIEP C710606 33A OYMC AC Drive – J1000 User Manual 59 Step Display/Result 1. 2. Turn on the power to the drive. The initial display appears. Press the key until the Setup Mode Screen appears. 3. 4. Press the key to view the parameter setting display. Scroll through parameters by pressing the key until C1-01 appears. 5. 6. Press to view the current setting value (10.0). (Number farthest to the left flashes) 7. Press until the desired number is selected.
(“1” flashes) Press the key and enter 0020.0. 8. Press and the drive will confirm the change. 9. The display automatically returns to the screen shown in Step 4.