Control) LOGICAL ADDRESS D*3TC Interruption) DIAGNOSIS ITEM disconnected from system. DIAGNOSIS CONTENT of radio receiver assembly. COUNTERMEASURE AND INSPECTED PARTS If error occurs frequently, replace radio agn receiver assembly. 01 (Communication Control) DF *4 Master Error Due to defective of component with a display, master function is switched to audio equipment. Error occurs in communication between sub-master (audio) and master component. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly. Check harness for communication system between radio receiver assembly and sub- master component.
01 (Communication Control) E0 *1 Registration Completion Instruction Error "Registration Completion Instruction" command from radio receiver assembly cannot be received. Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. 01 (Communication Control) E3 Registration Request Transmission Registration Request command is output from slave component. By reception of connection check instruction, Registration Request command is output from sub- master component. Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. 01 (Communication Control) E4 Plural Frame Abort Plural frame transmission is aborted.
Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. (d) Physical address: 16A, 16C RSA Panel (stereo component controller assembly) (Sub AVC-LAN) HINT: *1: It may be stored when the ignition switch is turned 1 min. again after start. *2: It may be stored when the ignition switch is turned again after start. *3: When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.
LOGICAL ADDRESS DTC DIAGNOSIS ITEM DIAGNOSIS CONTENT COUNTERMEASURE AND INSPECTED PARTS 01 *2 (Communication Control) D8 No Response to Connection Check Component shown by auxiliary code is or had been disconnected from system after engine start. D9 Check harness for power supply system of component shown by auxiliary code. Check harness for communication system of component shown by auxiliary code. 01 *2 (Communication Control) D9 Last Mode Error Component operated (sounds and / or images were provided) before engine stop is or has been disconnected with ignition switch in ACC or ON. Check harness for power supply system of component shown by auxiliary code.
Check harness for communication system of component shown by auxiliary code. 01 (Communication Control) DA No Response to ON / OFF Instruction No response is identified when changing mode (audio and visual mode change). Detected when sound and picture does not change by button operation. Check harness for power supply of component shown by auxiliary code. Check harness for communication system of component shown by auxiliary code. If error occurs again, replace component shown by auxiliary code. 01 *1 (Communication Control) DB Mode Status Error Dual alarm is detected. Check harness for power supply of component shown by auxiliary code.
Check harness for communication system of component shown by auxiliary code. 01 *3 (Communication Control) DC Transmission Error Transmission to component shown by auxiliary code has been failed. (Detecting this DTC does not necessarily mean actual failure.) If same auxiliary code is recorded in other component, check harness for power supply and communication system of components shown by sub code. 01 *2 (Communication Control) DE Slave Reset (Momentary Interruption) After engine is started, slave component was disconnected from system. Check harness for power supply of component shown by auxiliary code. Check harness for communication system of component shown by auxiliary code. cardi