LOGICAL 01 ADDRESS (Communication DTC DF DIAGNOSIS ITEM Master Error Due to defective condDitIiAonG NofO cSoImSp CoOneNnTt EwNithT a display, master function is switched to audio equipment. Error occurs in receiver assembly. COUNTERMEASURE AND INSPECTED PARTS Check harness for communication system agn Control) *4 communication between sub-master (audio) and master component. of radio receiver assembly. Check harness for communication system between radio receiver assembly and sub-master component. 01 (Communication Control) E0 *1 Registration Completion Instruction Error "Registration Completion Instruction" command from radio receiver assembly cannot be received.
Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. 01 (Communication Control) E1 *1 Audio processor ON error While source equipment is operating, AMP output is stopped. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly. 01 (Communication Control) E2 ON / OFF Instruction Parameter Error Error is detected in ON / OFF control command from radio receiver assembly. Replace radio receiver assembly. 01 (Communication Control) E3 Registration Request Transmission Registration Request command is output from slave component.
By reception of connection check instruction, Registration Request command is output from sub- master component. Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. 01 (Communication Control) E4 Plural Frame Abort Plural frame transmission is aborted. Since this DTC is provided for engineering purposes, it may be detected when no actual failure exists. (c) Physical address: 1F4 RSA Panel (Main AVC-LAN) HINT: *1:Even if no failure is detected, it may be stored depending on the battery condition or voltage for starting an engine. *2: It may be stored when the ignition switch is turned 1 min. again after engine start. *3:
It may be stored when the ignition switch is turned again after engine start. *4: When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored. LOGICAL ADDRESS DTC DIAGNOSIS ITEM DIAGNOSIS CONTENT COUNTERMEASURE AND INSPECTED PARTS 01 (Communication Control) D6 *1 Absence of Master Component in which this code is recorded has been disconnected from system with ignition in ACC or ON. Or, when this code was recorded, radio receiver assembly was disconnected. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly.
Check harness for power supply of RSA panel. Check harness for communication system of RSA panel. 01 *6 (Communication Control) D7 Connection Check Error Component in which this code is recorded has been disconnected from system after engine start. Or, when this code was recorded, radio receiver assembly was disconnected. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly. Check harness for power supply of RSA panel. Check harness for communication system of stereo component controller assembly panel. 01 (Communication Control) DC *2 Transmission Error Transmission to component shown by auxiliary code has been failed.
(This code does not necessarily mean actual failure.) If same auxiliary code is recorded in other component(s), check harness for power supply and communication system of components shown by sub code. 01 (Communication DD Master Reset (Momentary After engine is started, radio receiver assembly was Check harness for power supply of radio receiver assembly. Check harness for communication scysatermdi