switch) LOGICAL ADDRESS 41 DTC Malfunction DIAGNOSIS ITEM Malfunction due to mechanical failure. DIAGNOSIS CONTENT Replace radio receiver assembly. COUNTERMEASURE AND INSPECTED PARTS agn 63 (In-dash CD auto Changer) 42 No Disc Readout Disc cannot be read. Inspect CD. 63 (In-dash CD auto Changer) 44 CD Error Error is detected in CD auto changer. Replace radio receiver assembly. 63 (In-dash CD auto Changer) 45 EJECT Error CD cannot be ejected. Replace radio receiver assembly. 63 (In-dash CD auto Changer) 47 CD High Temp. High temperature is detected in CD auto changer. Replace radio receiver assembly.
63 (In-dash CD auto Changer) 48 CD Excess Current Excess current is applied in CD auto changer. Replace radio receiver assembly. (b) Physical address: 440 Stereo component amplifier HINT: *1: Even if no failure is detected, it may be stored depending on the battery condition or voltage for starting engine. *2: It may be stored when the ignition switch is turned 1 min. again after start. *3: It may be stored when the ignition switch is again after engine start. *4: When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.
LOGICAL ADDRESS DTC DIAGNOSIS ITEM DIAGNOSIS CONTENT COUNTERMEASURE AND INSPECTED PARTS 01 (Communication Control) 21 ROM Error Abnormal condition of ROM is detected. Replace stereo component amplifier. 01 (Communication Control) 22 RAM Error Abnormal condition of RAM is detected. Replace stereo component amplifier. 01 (Communication Control) D6 *1 Absence of Master Component in which this code is recorded has been disconnected from system with ignition in ACC or ON. Or, when this code was recorded, radio receiver assembly was disconnected. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly.
Check harness for power supply of stereo component amplifier. Check harness for communication system of stereo component amplifier. 01 *6 (Communication Control) D7 Connection Check Error Component in which this code is recorded has been disconnected from system after engine start. Or, when this code was recorded, radio receiver assembly was disconnected. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly. Check harness for power supply of stereo component amplifier. Check harness for communication system of stereo component amplifier.
01 (Communication Control) DC *2 Transmission Error Transmission to component shown by auxiliary code has been failed. (This code does not necessarily mean actual failure.) If same auxiliary code is recorded in other component(s), check harness for power supply and communication system of components shown by sub code. 01 (Communication Control) DD *3 Master Reset (Momentary Interruption) After engine is started, radio receiver assembly was disconnected from system. Check harness for power supply of radio receiver assembly. Check harness for communication system of radio receiver assembly. If error occurs frequently, replace radio receiver assembly.
Check harness for power supply ocf raadridoi