Last Modified: 6-7-2017 6.8:8.0.40 Doc ID: RM0000018PH003X agn Model Year Start: 2007 Model: Land Cruiser Prod Date Range: [08/2006 - ] Title: ENGINE HOOD / DOOR: REAR DOOR: DISASSEMBLY; 2007 MY Land Cruiser [08/2006 - ] DISASSEMBLY HINT: Use the same procedures for the LH side and RH side. The procedures listed below are for the RH side. 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation. 2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL (a) Using a screwdriver, remove the No. 2 door inside handle bezel as shown in the illustration. HINT:
Tape the screwdriver tip before use. 3. REMOVE NO. 1 DOOR INSIDE HANDLE BEZEL (a) Remove the screw. (b) Using a screwdriver, remove the No. 1 door inside handle bezel as shown in the illustration. HINT: Tape the screwdriver tip before use. 4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY (a) Using a screwdriver, remove the power window switch as shown in the illustration. HINT: Tape the screwdriver tip before use. (b) Disconnect the connector. 5. REMOVE REAR DOOR COURTESY LIGHT ASSEMBLY (a) Using a screwdriver, remove the door courtesy light, and then disconnect the connector. HINT: Tape the screwdriver tip before use. 6.
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY (a) Remove the 3 screws and 4 clips. (b) Insert a screwdriver between the door and door trim to pry the trim. NOTICE: Be careful not to damage the door and door trim. HINT: Tape the screwdriver tip before use. (c) Pull the trim upward to remove it. cardi