R th l t th h th i h l 7. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY (a) Remove the screw and the inside handle. (b) Disconnect the 2 control cables from the inside handle as shown in the illustration. gn 8. REMOVE REAR SPEAKER ASSEMBLY (a) Remove the 3 screws and speaker, and then disconnect the connector. 9. REMOVE REAR DOOR SERVICE HOLE COVER (a) Remove the clamps and wire harness. (b) Remove the service hole cover. NOTICE: Do not tear the cover. HINT: At the time of reassembly, bring out the 2 control cables and wire harness through the service hole cover. 10. REMOVE REAR DOOR BELT MOULDING ASSEMBLY (a) Using a scraper, remove the door belt moulding. HINT:
Tape screwdriver tip before use. 11. REMOVE REAR DOOR GLASS RUN 12. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY (a) Remove the 2 bolts, screw and division bar. 13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY (a) Disconnect the glass from the regulator arm and remove the door glass by pulling it upward. 14. REMOVE QUARTER WINDOW GLASS WITH WEATHERSTRIP 15. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY (a) Disconnect the connector, and then remove the 3 bolts for bolt B. Torque: 8.0 N·m {82 kgf·cm, 71in·lbf} (b) Loosen the bolt and window regulator for bolt A. Torque: 8.0 N·m {82 kgf·cm, 71in·lbf} HINT: cardia