B [O] : Explains the system outline. [P] : Indicates values or explains the function for reference during troubleshooting. [Q] : Indicates the reference page showing the position on the vehicle of the parts in the system circuit. Example : Part ”L4” (Light Failure Sensor) is on page 36 of the manual. ∗ The letter in the code is from the first letter of the part, and the number indicates its order in parts starting with that letter. Example : L 4 Б Parts is 4th in order Light Failure Sensor [R] : Indicates the reference page showing the position on the vehicle of Relay Block Connectors in the system circuit. Example :
Connector ”1” is described on page 18 of this manual and is installed on the left side of the instrument panel. [S] : Indicates the reference page showing the position on the vehicle of J/B and Wire Harness in the system circuit. Example : Connector ”3C” connects the Instrument Panel Wire and J/B No.3. It is described on page 22 of this manual, and is installed on the instrument panel left side. [T] : Indicates the reference page describing the wiring harness and wiring harness connector (the female wiring harness is shown first, followed by the male wiring harness). Example : Connector ”IE1” connects the floor wire (female) and Instrument panel wire (male).
It is described on page 42 of this manual, and is installed on the left side kick panel. [U] : Indicates the reference page showing the position of the ground points on the vehicle. Example : Ground point ”BO” is described on page 50 of this manual and is installed on the back panel center. [V] : Indicates the reference page showing the position of the splice points on the vehicle. Example : Splice point ”I5” is on the Cowl Wire Harness and is described on page 44 of this manual.