− INTRODUCTION FOR ALL OF VEHICLES IN−15 (g) AIRBAG SENSOR ASSEMBLY (1) Never reuse the airbag sensor assembly involved in a collision when the SRS has deployed. (2) The connectors to the airbag sensor assembly should be connected or disconnected with the sen- sor mounted on the floor. If the connectors are con- nected or disconnected while the airbag sensor as- sembly is not mounted to the floor, it could cause undesired ignition of the supplemental restraint sys- tem.
(3) Work must be started after 90 seconds from the time the ignition switch is turned to the ”LOCK” posi- tion and the negative (−) terminal cable is discon- nected from the battery, even if only loosing the set bolts of the airbag sensor assembly. (h) WIRE HARNESS AND CONNECTOR The SRS wire harness is integrated with the instrument panel wire harness assembly. All the connectors in the system are a standard yellow color. If the SRS wire har- ness becomes disconnected or the connector becomes broken due to an accident, etc., repair or replace it as shown on page RS−48 . 15 Author : Date: