Statements of Compliance CE Class A MicroHAWK Smart Cameras have passed Class A testing for the standards listed below, including U.S. (FCC), European (EN), and Canadian EMC requirements (ICES). • 2011/65/EU • EN 50581:2012 • 2004/108/EC • EN 55022:2010 For Class A Products • EN 55024:2010, including: • IEC 61000-4-3:2010 • IEC 61000-4-4:2012 • IEC 61000-4-5:2014 • IEC 61000-4-6:2013 • IEC 61000-4-8:2009 • IEC 61000-4-11:2004 • EN 61000-3-2:2014 • EN 61000-3-3:2013 • FCC 15.109:2015 For Class A Products • FCC 15.107:2015 For Class A Products • ICES-003:2012 For Class A Products CE Class B MicroHAWK Smart Cameras have passed Class B testing for the standards listed below, including U.S.
(FCC), European (EN), and Canadian EMC requirements (ICES). The MicroHAWK had a ferrite core installed on the USB cable adjacent to the MV-20 for all tests. The ferrite used was classified as a lower and broadband part for frequencies in the range of 1-300 MHz. • 2011/65/EU • EN 50581:2012 • 2004/108/EC • EN 55022:2010 For Class B Products • EN 55024:2010, including:
• IEC 61000-4-3:2010 • IEC 61000-4-4:2012 • IEC 61000-4-5:2014 • IEC 61000-4-6:2013 • IEC 61000-4-8:2009 • IEC 61000-4-11:2004 • EN 61000-3-2:2014 • EN 61000-3-3:2013 • FCC 15.109:2015 For Class B Products • FCC 15.107:2015 For Class B Products • ICES-003:2012 For Class B Products EMC ESD Electromagnetic compatibility (EMC) exception: The MicroHAWK was tested for electrostatic discharge immunity per IEC 61000-4-2. The following conditions and exclusions apply for proper use of the MicroHAWK and for ESD immunity as it applies to the overall system in which the MicroHAWK is integrated.
The MicroHAWK is not intended for stand-alone functionality and is meant to function as part of a larger system. Per paragraph 8.3.2 of IEC 61000-4-2, sections A and C: A.) Points and surfaces that are only accessible by maintenance. Justification: The MicroHAWK is approved for use when installed as a component and when it is no longer accessible to the end user except at the time of installation or when maintenance is performed. The MicroHAWK may be accessed for maintenance provided that proper ESD handling procedures are followed. C.) Points or surfaces of equipment that are no longer accessible after fixed installation. Justification:
The MicroHAWK is installed as a component in a system and the device is no longer accessible. The end user should be trained in ESD safety and handling. The system in which the MicroHAWK is installed should be properly grounded for power ground and earth ground. The MicroHAWK should not be placed next to devices that build up excessive static charge.