embedded web server system requirements To use the embedded Web server, you must have a TCP/IP-based network and a Web browser installed on your computer, either Netscape Navigator 4.7x or Microsoft Internet Explorer 5.0x and above. You do not need Internet access to open and use the embedded web server, however, some features will not be available. Note The embedded web server can be accessed from any operating system that supports the TCP/IP protocol and a Web browser. The embedded Web server does not support IPX/SPX- based network printer connections and cannot be accessed with a parallel cable. You cannot view the embedded Web server pages from outside a firewall.
gaining access to the embedded web server You can gain access to the embedded Web server in the following ways: • From the Toolbox (Windows only): Launch the embedded Web server from the Information tab in the Toolbox. The default Web browser for the computer opens and displays the embedded Web server information. • From a Web browser : In a supported Web browser on your computer, type the IP address assigned to the printer. For example, if the printer’s IP address is 123.123.123.123, you would type http://123.123.123.123 into your Web browser. If you do not know the IP address for the printer, it is listed on the printer configuration page.
After you gain access to the embedded Web server, you can bookmark it so that you can return to it quickly in the future. information pages device status page Device Status: This section displays the current status of the printer. This section also displays the (select button), PAUSE/RESUME, and CANCEL JOB buttons. When clicked, these buttons are equivalent to physically pushing the buttons on the printer. Supplies: This section shows the life remaining of ink cartridges and printheads, with 0 percent representing a supply that is empty. This section also provides supplies part numbers. To order new supplies, click Order Supplies in the area on the left side of the window.
To visit any Website, you must have Internet access. Media: This section displays information about the installed trays, including the type and size of media loaded, as well as each tray’s status. To change the tray settings, click Change Settings. 3-80 hp restricted use and maintain