１３ .Setting VNC for the NB １３ Setting VNC for the NB Since the VNC function has been added to NB-Designer V1.46 and later, a remote connection using the HMI Remote Viewer is also supported by NB-series. How to set VNC function for NB-series is described below. How to connect the WE70 AP, iOS device, and HMI Remote Viewer is the same as when using NA. Accordingly, for the information, refer to sections 9 to 11 in this guide. １３ - １ Setting IP Address and VNC with the NB-Designer Perform the following procedure to enables IP address and VNC function with the NB-Designer. 32 1. Double-click the PT placed on the Configurations and Setup window to display PT property.
Configurations and Setup window to display PT property. 2. Select the “PT” tab and set the IP address and subnet mask for network setting as follows; IP Address：192.168.250.2 Subnet Mask：255.255.255.0 3. Select “Enable VNC”