16 6 After starting Autovision, if the smart camera is displayed in the device selection list, proceed to Step 8. If the AutoVision startup screen does not appear, go to step 7. 7 If the AutoVision startup screen does not appear, it means that communication between the smart camera and the PC has not been established so please check the following. ・Does the F430 and the PC have a proper physical (cable) connection? ・Are the respective IP Addresses on the PC and on the F430 Smart Camera set correctly? → Refer to 4. for setting the IP Address of the PC. ・Do a hardware reset of the F430.
→ When turning the power on, press and hold the setup button on the Smart Camera body until its light turns on. 8 After selecting the smart camera, the settings screen will display. Check the settings indicated by the red boxes. Some are the default settings and do not need to be changed. Serial port: RS232C-1 Baud Rate: 115200 Data bit: 8 Parity: None Stop Bit: 1 Flow control: None