Hardware set-up with actual hardware installed and connected 17.) Right click on the master coupler “NX-EIC202 Master.” You the name was change earlier, it may have that name here instead. 18.) Connect the Ethernet cable from the computer to the coupler. 19.) Right click on the master coupler “NX-EIC202 Master”, select “Coupler Connection (USB)” at the bottom of the pulldown list, then select “Online” 20.) Right click again on the master coupler “NX-EIC202 Master”, the select “Compare and merge with actual configuration.” 21.) Select “Apply actual network configuration” and then “Okay.” Close the box. Here is an example of a configuration. Note: END01 is the end cap.
Sysmac Studio automatically added it to the configuration. The actual piece should have come with the coupler. QSG-NX-S-STANDALONE - Version 3.2 Feb. 27, 2015 Page 13 OMRON AUTOMATION & SAFETY • © 2015 Omron Electronics LLC • www.omron247.com