1. Remote Access Settings 5. Remote Access Settings The parameters used in this guide are shown below. The following setting item is required to log in to the GateManager as an administrator. The setting value must be determined in advance as this information is determined and managed by the user itself. The SiteManager settings are given below. The setting items vary according to how the SiteManager is connected to the internet. Startup Guide – Remote Access - RT1 Series - P151-E1-02 9 5.1. GateManager Settings Setting item Setting value Remarks Password ●●●●●●●●●●●● The password to log in as a GateManager administrator.
The password must be composed of eight or more characters, including letters, numbers and special symbols. It is especially recommended that the password include alphanumeric characters with at least twelve upper and lower case letters, numbers and special symbols such as " . ", " , ", " ? ", " ! ", " " and " “ ". 5.2. SiteManager Settings Setting item Setting value Remarks (1) LAN connection (2) 3G/4G connection (3) WiFi connection GateManager Address (Information described in the e-mail sent to the user) GateManager connection information Domain Token (Information described in the e-mail sent to the user) Appliance Name SM01 (It is determined by the user.
SM01 is used in this guide.) Management name of the SiteManager Uplink port DHCP － － (1) LAN connection If the network environment requires settings in Static mode, obtain and set an available IP address from your network administrator. Uplink2 (Mobile broadband) － (information provided by your mobile carrier with a SIM card) － (2) 3G/4G connection ASN / User Name / Password Uplink2 (WiFi) － － (WiFi connection information according to the usage environment) (3) WiFi information (connection destination) WiFi SSID / WiFi Key DEV port IP address: 192.168.250.10 Subnet mask:
255.255.255.0 (In this guide, they are set to the values that belong to the same subnet as the Controller.) IP address and subnet mask of DEV1–DEV3 ports Device Agents Device Name：NX01 (It is determined by the user. NX01 is mostly used in this guide.) Management name of the target device Device Type：omron / Ethernet PLC (They are selected from the pre-registered classifications in the SiteManager.) Manufacturer name of the target device (Controller) / device type Device IP & Parameters: 192.168.250.1 (The default value of the port 1 on the Controller is used in this guide.) IP address of the target device (Controller)