Connection Procedure for Remote Access 6.3. SiteManager Setup Set up the SiteManager. Although there are several ways to set up the SiteManager, this guide describes how to connect the DEV ports on the SiteManager directly to your personal computer with an Ethernet cable and how to set it up in the browser. Additional Information There are other ways to set up the SiteManager. For more information refer to the instruction sheet delivered with your product for details.
- Load the configuration file created on the GateManager into the SiteManager via a USB stick 20 Startup Guide – Remote Access - RT1 Series - P151-E1-02 - Configure the SiteManager by using the Wizard-based Windows application "Appliance Launcher" installed on your personal computer 6.3.1. Hardware Settings Make the hardware settings for the SiteManager and connect the cables. Precautions for Correct Use Make sure the power supplies are OFF before setting up. If either of them is ON, the settings described in the following steps and subsequent procedures may not be applicable. 1 Make sure Power supplies for SiteManager and Controller are OFF.