5 ． Applicable Devices and Device Configuration Precautions for Correct Use If you use a version higher than the one specified, the procedures and related screenshots Update Sysmac Studio to the version specified in this Clause 5.2. or to a higher version. described in Section 7. and subsequent sections may not be applicable. In that case, use the equivalent procedures described in this document by referring to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504). Additional Information For specifications of 24 VDC power supply available for Switching hub, refer to the Switching Hub W4S1-series Users Manual (Cat. No. 0969584-7).
Additional Information For specifications of 24 VDC power supply available for Robot Controller, refer to the eCobra 600, 800, and 800 Inverted Robots User’s Guide (Cat. No. I593-E). Additional Information The system configuration in this document uses USB for the connection between Personal computer and Controller. For information on how to install the USB driver, refer to A-1 Driver Installation for Direct USB Cable Connection in Appendices of the Sysmac Studio Version 1 Operation Manual (Cat. No. W504). 9