Instruments and Controls “One-Touch” Up with “Anti-Trap” Note: If the battery is disconnected, the “One-Touch” and “Anti-Trap” features will be lost. To restore this feature, fully close the window and hold the switch for 5 seconds, and then fully open the window and press the switch for 5 seconds. The driver’s window control switch (1) has the “one-touch” up function. Lifting the switch to the “2” position for a short time and releasing will automatically close the window completely. Window movement can be stopped at a desired position at any time by briefly operating the switch again.
The “Anti-Trap” function is a safety feature which prevents the window from fully closing if an obstruction is sensed - if this happens the window will open slightly to allow the obstruction to be removed. Note: DO NOT operate the power window controls continuously several times in a short time frame, otherwise the power window controls may be disabled to protect the motor. If this occurs, please wait a few seconds until the motor cools down. In the case of the driver’s window with “One Touch and Anti-Trap” please wait 30 seconds prior to operation. In some cases it may take 30 minutes to completely cool down, during which time the negative battery lead should not be disconnected. 32