Special activation Quick Commanus Depending on the features available with your alarm system you may have special activations that can be used. Refer to the front of this guide for special activations from the control stations. A special activation may be a door strike or a light, etc. The activation may be timed or you may be able to turn it on activation: {. Enter your passcode. ENTER PASSCODE. -: || abekeeeehee bene: ACTIVATIONON ~ 2. then "C” to enable/ disable the chime. Chime Enable When the system is disarmed, a chime sounds at the or off. To activate a special Allow you to easily reset the smoke detector and enable the chime.
To use the Quick Commands, press "Enter", then "B" to reset the smoke detector or "Enter", control station(s) when a chime monitor point is violated. The chime is used to monitor points without arming the system or causing alarms. This feature allows you to tum the chime on or off. Resetting Smoke Detectors Press “Enter.” If a smoke detector is connected to Zone | and the A duress passcode may be used with the special activation feature. The special activation shall control station. detector goes into alarm, you must manually reset it ata work as normal, but a duress alarm shall be sent to The smoke detectors are restored to a ready state.
If they someone is forcing you to open a door against your do not restore, repeat the previous steps. If the detectors do not reset after a second time, call your installing the central station. This feature can be useful if will. Your duress passcode is your user passcode incremented by two. For example, the passcode 2345 would become 2347 and 2349 would become 2351. company.