Checking brake pads and discs for wear/replacing Checking brake disc wear (Inspections II and III) Checking front brake pad wear R21000220 • Examine the brake discs carefully for cracks, damage, distortion, wear and score-marks. R21000200 Brake disc wear limit: front: ............................................. 4.5 mm (0.18 in) rear: .............................................. 4.5 mm (0.18 in) • Check/measure thickness of brake pads. e Caution: Brake pad thickness must not fall below the minimum value. Always replace the brake pads as a complete set. Minimum pad thickness: .............
1.0 mm (0.04 in) Checking rear brake pad wear R21000210 • Make sure that the brake disc is not visible through the bore in the inner brake pad. • If necessary, check/measure thickness of brake pads. e Caution: Brake pad thickness must not fall below the minimum value. Always replace the brake pads as a complete set. Minimum pad thickness: ............. 1.5 mm (0.59 in) 00.29