Checking brake pads, brake discs for wear and renewing if necessary Inspection II, III Front wheel brake LT000110 • Measure thickness of brake disc with a microm- eter. Wear limit ....................................................4.5 mm • Remove rear section of mudguard. Rear wheel brake Min. pad thickness on carrier plate....1.5 mm (0.06 in) • Lever off cap from brake caliper. • Remove brake caliper. • Drive out retaining pins (1) from wheel side. • Remove brake pads by pulling upward. • Install in the reverse order of removal. • Install in the reverse order of removal. Mininum pad thickness on carrier plate.......1.5 mm ..................................................................
(0.06 in) Wear limit of brake disc...............................4.5 mm ................................................................ (0.177 in) L Note: Before installing the brake caliper, completely press back pistons with resetting tool (1), BMW No. 34 1 500 . 00.14 LT00 1 LT00 0090 • Remove brake caliper. L Note: It is not necessary to release the brake line at the brake caliper if only the brake pads are to be changed. • Drive out retaining pin (1). • Remove brake pads by pulling in downward direction. e Caution: The brake pad thickness (arrows) must not drop be- low the minimum specified value. Change pads only as complete sets. 1 LT000120 34 1 500 LT000100