4.2 Unpack the Shipment 4.2 Unpack the Shipment Unpack the shipment on a clean, level, electrostatic discharge-safe (ESD-safe) surface that is adjacent to the installation location. Make sure that the workspace is large enough to accom- modate both the shipping carton and the unpacked appliance. CAUTION: ESD DAMAGE RISK . Protect the appliance from damage caused by electrostatic discharge (ESD). Wear a grounded wrist-strap or shoe strap before you remove the antistatic cover. ATTENTION: RISQUE DE DЙCHARGE ЙLECTROSTATIQUE . Protйger l’appareil contre les dommages provoquйs par les dйcharges йlectrostatiques (ESD).
Portez un bracelet antistatique а la poignйe ou а la cheville avant de retirer le couvercle antistatique. Before You Unpack the EM2100 Before you unpack the appliance: l Orient the carton only as indicated by its labeling (This Way Up). l Carefully inspect the packaging for evidence of damage during transit. If you find pack- aging damage, request that the carrier’s agent is present when you open the packaging. As the appliance is unpacked: 1. Compare the actual items received (not just the packing slip) with your equipment pur- chase order. 2. Verify that all items are present and that the shipment is correct. Refer to Items Sup- plied with the EM2100 on page 5. 3.
Inspect each component for external damage as you unpack it. Contact us immediately if you see any damage. Unpack the EM2100 Shipping Carton 1. Place the shipping carton on a stable, flat surface. 2. Use only a safety box cutter to cut the packing tape. Do not use any other type of knife because you might damage the contents. Open the carton as shown in Figure 4-1. 18 EM2100 Installation Guide 20569-000 Rev. A