4.3 Sliding Rail Kit for Rack Mounting 1. Locate the tab on the sliding rail [1]. This tab indicates the front of the sliding rail. Align the sliding rail with the applicance chassis. 2. Attach the sliding rail with four M4x6 screws [2]. Torque each screw to 2 ft-lb (3 N∙m). 3. Repeat Step 1 and Step 2 for the other sliding rail. Attach the Outer L-shaped Brackets to the Sliding Track Attach the front and rear outer L-shaped brackets to the sliding track as follows. Figure 4-5. Attach the Front and Rear Outer Adjustable L-Brackets to the Track (Right Assembly Shown). 1. Identify the front and rear outer L-brackets by a letter stamped into the metal ("F" - front and "R" - rear). 2.
Align the front outer L-bracket [2] with the front end of the sliding track [1]. 3. Attach the front outer L-bracket with two M4x4 screws and M4 washers [3]. Torque each screw to 2 ft-lb (3 N∙m). 4. Align the rear outer L-bracket with the rear end of the sliding track [4]. 5. Attach the rear outer L-bracket with two M4x4 screws and M4 washers [5]. Do not tighten the screws and allow the bracket to slide. 6. Repeat Step 1 through Step 5 for the other brackets and sliding track. Attach the Sliding Tracks to the Rack Posts Use the following procedures to adjust and attach the sliding tracks to a typical rack post pro- file.
Adjust the Sliding Tracks to Span the Rack Posts Use the following procedure to adjust the sliding tracks before attaching. 24 EM2100 Installation Guide 20569-000 Rev. A