Chapter 3: Fleet Manager Configuration and Operation 26 Fleet Operations Workspace Core User's Guide 20569-020 Rev. A 7 Configure Paired Appliances The default (shipped) configuration for an EM2100 is Unconfigured. The user will need to con- figure it as either Standalone or Paired Fleet Manager. To create an Autosync pair, refer to Configure the Primary Appliance on page 27 and Con- figure the Secondary Appliance on page 28. The paired appliances then function as follows: l The Primary unit is a fully-functional EM2100, running the Fleet Operations Workspace Core and actively controlling the fleet. l The Secondary unit is powered on, with its Web interface accessible to the Primary unit.
However, the fleet management functions are inactive on the Secondary unit, and it is inaccessible from MobilePlanner or AMRs. The Primary Fleet Manager has two active IP addresses, while the Secondary has only one act- ive IP address. 2100 Autosync — Ethernet Cabling The following figure shows the physical connection of Ethernet cables to the appliances. Figure 3-1. Cabling for an EM2100 Fleet Manager Pair Callout Description 1 EM2100 configured as a Primary appliance. 2 EM2100 configured as a Secondary appliance. 3 Cat-V Ethernet cables to the LAN switch:
Primary and Secondary MGMT ETH1 l Primary and Secondary FLEET ETH2 l sks in Autosync Setup Before you set up Autosync, make sure that you have: