15. DTC: P0325, Shock Sensor Circuit Trouble (see Table 1-28) Table 1-28 16. DTC: P0335, Crankshaft Position Sensor Signal Trouble (see Table 1-29) Table 1-29 54 S/N Operation Test Results Actions 1 Connect the diagnostic instrument and adapter, and turn the ignition switch to OFF. Next step 2 Disconnect the shock sensor from the harness. Measure the resistance between pin 1# and pin 2# with a multimeter. Is the resistance greater than 1MΩ? Yes Next step No Replace sensor 3 Check for open circuit or short to power supply or ground between the pin 1#, 2# of the shock sensor and the pin 19#, 20# of the ECU. Yes Repair or replace harness No Next step 4 Replace the shock absorber as required.
Make the rotation speed of the engine exceed 2200r/m. Check again for DTC P0325. Yes Diagnosis help No Check if by accident S/N Operation Test Results Actions 1 Connect the diagnostic instrument and adapter, and turn the ignition switch to OFF. Next step 2 Disconnect the rotation speed sensor from the harness. Measure the resistance between pin 2# and pin 3# with a multimeter. Is the resistance between 770Ω and 950Ω under the temperature of 20℃? Yes Next step No Replace sensor 3 Check for open circuit or short to power supply or ground between the pin 2#, 3# of the rotation speed sensor and the pin 34#, 15# of the ECU.
Yes Repair or replace harness No Next step 4 Check the fly wheel singal panel for normal operation. Yes Diagnosis help No Replace signal panel