SAMI G S 8.8 Drive Parameters and Their Factory Settings (Factory Macro). 1 ) 400 V in 400V units, 500 V in 500 V units 33 MAIN GROUP PARAMETER DEFAULT CUSTOMER SET- Operating Data (not a Main) Operating Data 9 Control Place Keypad R1 TING 12 Ext Ref 1 or 2 Ref1 23 Parameter Lock Open xxx Start-Up Data A Language English B Application Factory C Applic.
Restore No D Supply Voltage 400/500 V 1) E Pole Number 4 F Motor Nom Current (I ) M I of SAMI N G Motor Nom Power (P ) M P of SAMI N H Cos phi of Motor 0.83 10 Cont Connections 11 Dig/Analog Input Sel 1 Run Enable Yes 2 Ext Cont Place Sel Keypad 3 Ext 1 I/O Cont Sel DI1,2 4 Ext 2 I/O Cont Sel Not Sel 5 External Ref1 Sel AI1 6 External Ref2 Sel Keypad 7 Const Speed Sel DI3,4 8 Direction Request 9 Fault Reset Sel Not Sel 10 Acc/Dec 1 or 2 Sel 1 1 P a rDamI6 Lock Sel Keypad 12 Analogue Inputs 1 Filter AI1 0.1s 2 Minimum AI1 0V/0mA 3 Invert AI1 No 4 Filter AI2 0.1s 5 Minimum AI2 0V/0mA 6 Invert AI2 No 13 Ref Value Scaling 1 Ext Ref1 Min Scale 0 Hz 2 Ext Ref1 Max Scale 50 Hz 3 Ext Ref2 Min Scale 0 Hz 4 Ext Ref2 Max Scale 50 Hz 14 Output Signals 1 Analogue Out 1 Out Freq 2 Analogue Out 2 Out Cur 3 Relay RO1 Out Ready 4 Relay RO2 Out Run 5 Relay RO3 Out Fault 15 Analogue Outputs 1 Filter AO1 2 s 2 Minimum AO1 0 mA 3 Invert AO1 No 4 Filter AO2 2 s 5 Minimum AO2 0 mA 6 Invert AO2 No 16 Out Sig scaling 1 Scale AO1 100 % 2 Scale AO2 100 % 17 Ext.
Communi- cation 1 SAMI ID number 0 2 Bit rate select 9600 bit/s 3 Time-out select 100.0 s 4 Comms. fault funct. None 5 Bad message counter (number) 6 Good mess counter (number)