2. Raise the clutch lever so it is just touching the rub- ber stop on the handle. See figure 11. With the clutch lever in this position, swing the traction drive cable down and simply hold it beside the drive bracket. Do not pull on spring. Do not move bracket. The hook on the end of the spring must line up with the center of the hole in the drive -._--.------bracket. See figure 12. Traction Dri_ !e Cal0te If it does not, adjust the nut on the cable by sliding the spring up and using a 7116" wrench and pliers to move the nut on the end of the cable up or down as necessary until the hook on the spring aligns with the center of the hole in the bracket. See figure 12, inset.
Line UpCenter of HookWith Centerof Hole Lengthl FIGURE12. Do not place the pliers on the threaded part of the cable. 3. Hook the traction drive cable into the drive lever. There should not be any tension on the spring when the clutch lever is in the released posi- -.,_-_--tion (up) position. See figure 13. To check the adjustment, push the clutch lever down against the handle. The drive bracket should move up. Release the clutch lever. Drive bracket should return to the neutral (down) position, and the clutch lever should spring up, away from the handle. Hooke _ in Drive Brack _=t FIGURE 13. Auger Drive Clutch Lever ATTACHING THE AUGER CABLE 1.
Hook the "Z" fitting on the end of the auger cable into the bottom hole in the auger drive clutch lever (left hand side of handle). Hook the fitting from the .,=----.---inside to the outside as shown in figure 14. 1/4 "Z" Fitting Hooked in Bottom Rubber Stop FIGURE 14.