GT-6(T) 15. fig.LCD26 Calibrate EXP RESTORING THE FACTORY SETTINGS (FACTORY RESET) 1. Turn off the power. fig.LCD27 1) The maximum and minimum values of the EXP pedal are set up. 2. While holding down PREAMP/SPEAKER On/Off button and [TYPE VARIATION], turn on the power. fig.FR-1e The Factory Reset range setting screen appears in the display. fig.arrow The area of data you wish to factory reset. 3. Press PARAMETER [ ] button to move the cursor, and rotate the PATCH/VALUE dial to specify the range of settings you want to restore to factory settings. * To cancel Factory Reset, press [EXIT] button. fig.LCD26 2) To set up the minimum value, press the [WRITE] button. System:
System parameters, Harmonist scales, Auto Riff phrases, and Preamp, Overdrive/Distortion, and Wah Custom Edit parameter settings fig.LCD28 #1-1-#35-4: fig.arrow 4. If you want to proceed with the factory reset, press [ENTER] button. Settings for Patch Number 1-1 through 35-4 The specified range of data will be returned, and return to the Play screen. fig.LCD26 HOW TO UPDATE SYSTEM SOFTWARE Required items 3) Fully press the EXP pedal and release your hands. 4) To set up the maximum value, press the [WRITE] button. • Sequencer (MC-80, etc.) • MIDI cable • Update Disk (#17041087) When the calibration setup is completed, will automatically proceed to the next inspection. 16.
fig.LCD29 Factory load * Notes Do not turn the GT-6 unit’s power off while writing the system software. The GT-6 will not operate because the system will not be properly written into the flash ROM. * Notes After updating, execute “TEST:15.Calibrate EXP” and “TEST:16.Factory Load” while in the test mode. To overwrite the factory preset data, press the [WRITE] button three times. fig.LCD30 The System Update Via SMF The GT-6 system is supplied in standard MIDI file (SMF) format. The following SMF data is stored on the disk. Starting with GT6_01.mid, transfer all data to the GT-6 in the respective order. This ends test mode. When the following displayed appears, turn off the power.
GT-6 System Ver.*.** SMF Disk : GT6_01.mid, GT6_02.mid, GT6_03.mid, GT6_04.mid, GT6_05.mid, GT6_06.mid, GT6_07.mid, GT6_08.mid After the test mode is completed, connect external equipment that has a DIGITAL IN terminal to DIGITAL OUT, and confirm that the sound is properly output from DIGITAL OUT of the GT-6. 17. DIGITAL OUT Update the GT-6’s system in the following order. 1. Using a MIDI cable, connect the MIDI OUT connector of the sequencer to the MIDI IN connector of the GT-6. 2. Turn the GT-6’s power on while pressing the [FX-2] and [PEDAL ASSIGN] and [UTILITY] buttons simultaneously.
The unit is in reception standby status if the LCD displays “Flash Update ALL BLOCK” then displays “Waiting SMF Data [GT6_01.mid]”. 19