Loading/Replacing the Paper Follow the steps below to load the paper for the first time, change classification or type of the paper (roll paper or fanfold paper) or replace the paper. Loading the paper is different depending of the type of the paper to use roll paper or fanfold paper. • For roll paper/ wrist band, see Loading/Replacing the Roll Paper on page 80 . • For fanfold paper, see Loading/Replacing Fanfold Paper on page 90 . • Use paper that meets the printer specification. For details about paper specification, see Paper Specifications on page 32 . • When exchanging paper without changing paper type, media position detection, or paper width, see Paper Specifications on page 32 .
Follow the steps below to load the roll paper/ wrist band. • Loading the paper for the first time: 2 to 5 • Using up the paper completely (loads same type of paper): 1, 5 • Changing paper type or classification: 1 to 5 1. Removing the paper (page 81) 2. Setting for media position detection (page 83) 3. Removing the paper feed guide (page 84) 4. Adjusting roll paper guide/paper ejection guide (page 85) 5. Loading the paper and turning on the printer (page 88) Before loading or replacing the roll paper, make sure that the DIP switch 3 (paper selection) setting is OFF (roll paper). See Setting the DIP Switches on page 78 for DIP switches settings. 80 Loading/Replacing the Roll Paper