English 4. Turn the cassette knob on the cartridge in the direction of the arrow 2 or 3 times to remove any slack. 5. Insert the ribbon, and rotate the cassette knob 2 or 3 more times, as shown in illustration 3 . 6. Make sure the ribbon has no wrinkles or creases and is installed below the print head as shown on the label inside the printer. 3 Installing the Roll Paper 1. Press the button, as shown in illustration 4 , to open the cover. 2. Insert the roll paper as shown in illustration 5 . Make sure that it is inserted correctly as shown in illustration 6 . 5 6 3. Pull out a small amount of paper, close the cover, and tear off the paper. Inserting Slip Paper Note:
Do not use wrinkled or curled paper. 1. When the SLIP LED flashes, insert slip paper, using the right edge of the slip paper inlet as a guide (see illustration 7 ). 2. When you insert the slip into the inlet as far as it will go, the sensor detects the slip, the SLIP LED changes from flashing to on, and the printer draws the paper in and prints it. 3. After printing is complete, the SLIP LED goes off, and you can remove the slip. Note: An optional front extension table (WT-5000) is available for users who need it to enable handwriting on paper or other uses. 7 2 1 8 TM-H5000II User’s Manual 4