Chapter 3 Advanced Usage • [Roaming] and [AP Density] in the [Wireless] menu can be set only when the Wi-Fi model's firmware is version 1.17 or later. • [Wellknown Community Name] in the [SNMP] menu can be set only when the Wi-Fi model's firmware is version 1.19 or later. The initial value is enabled. If you disable this setting, there are the following restrictions. ∗ TM drivers The battery status cannot be acquired. Port opening is extended by approximately 2 seconds. ∗ Deployment Tool The model name cannot be acquired. ∗ EpsonNet Config/Monitoring Tool The model name, status, and setting information cannot be acquired. The setting cannot be changed.
• You can also select the following functions from the optional configuration menu. ∗ Administrator Information : Use to register administrator name and the printer location. ∗ Reset : Use to reset the interface card or restore the default settings. ∗ Password : Use to change the password. For the default password, see "Default administrator password for setting" on page 88 . 3 63