2. PRINTER SETUP ENGLISH VERSION EO1-33094 2.3 Loading Supplies 2.3.1 Loading the Media (Cont.) 12. Batch mode In batch mode, the media is continuously printed until the number of labels/tags specified in the issue command has been printed. 13. Loading with peel off module When the optional Strip Module is fitted, the label is automatically removed from the backing paper at the Strip Plate as each label is printed. (1) Remove enough labels from the leading edge of the media to leave 500mm of backing paper free. (2) Insert the backing paper under the Strip Plate. (3) Wind the backing paper onto the Take-up Spool and fix it in position with the Take-up Clip.
(Wind the paper counter-clockwise around the spool.) (4) Rotate the Take-up Spool counter-clockwise a few times to remove any slack in the backing paper. (5) Set the Selection Switch mounted on the Rewinder Assembly to STANDARD/PEEL OFF position. NOTES: 1. Be sure to set the Selection Switch to STANDARD/ PEEL OFF position. 2. The backing paper is easier to feed back to the Take-Up Spool if the Front Plate is removed. 3. Fit the Take-Up Clip so that the longer side of the clip is fitted into the shallow groove in the Take-Up Spool. 4. The backing paper can be wound directly onto the Take-up Spool or a paper core. Take-up Spool Strip Plate Take-up Clip Backing Paper E2- 8