1 Setup of Camera & Software Vision 1-2 Setup of Camera & Software Vision (FJ-S ЈЈЈЈ Series) 1 1-2-6 Setup of Software 3 Click OK button and the changes are enabled. Initializing camera settings 1 Clicking Restore the default setting on Camera Configuration Tool restores default setting. 1-13 FJ Series (Camera & Software Vision Package) PC Vision System Camera Setup Guide (Z428-E1) Category Item Value Description Output port setting Signal select • Trigger ready • Strobe trigger • Trigger ready: The signal which is ON while trigger signal can be input. • Strobe trigger: The signal for strobe trigger. Line invert • Enable • Disable Invert signal select polarity. • Enable:
Invert (Photo coupler OFF) • Disable: Not invert (Photo coupler ON) Strobe trigger set- ting Signal delay time(μs) 0 to 4095 This setting is valid when Signal select is Strobe trigger. Set the delay time. Signal pulse-width time(μs) 0 to 4095 This setting is valid when Signal select is Strobe trigger. Set the pulse-width time. I/O monitor TRG port • ON • OFF Indicate the input state of TRG port. Output port • ON • OFF Indicate the output state of Output port. Ethernet Packet size 220 to 16404 Set the packet size for transmitting from a camera. Inter-Packet delay FJ-SCG: 0 to 42864 FJ-SG: 0 to 86251 FJ-SC2MG: 0 to 16430 FJ-S2MG: 0 to 35579 FJ-SC5MG: 0 to 439 FJ-S5MG: 0 to 3736 FJ-SC5MGR:
0 to 12487 FJ-S5MGR: 0 to 12487 (Unit: Tick, FJ-S£ £££ Camera: 1 [Tick] = 8 [ns]) Set the delay time of packets between. Set for preventing packet-loss because of connecting multiple cameras in one LAN. Set with Packet transmission de- lay. Packet transmis- sion delay 0 to 50000000 (Unit: Tick, FJ-S£ £££ Camera: 1 [Tick] = 8 [ns]) Set the delay time to transmit packets. Set for preventing packet-loss because of connecting multiple cameras in one LAN. Set with Inter-Packet delay.