Connector Ports *Position of connector ports on projector *1 HDCP 2.2 is supported. *2 Make sure you use LAN cables that are straight STP cables, category 5e or higher, and recommended by the HDBaseT Alliance. *3 Commercially available etherCON LAN cables are also supported. *4 Only analog RGB signals can be output from the BNC In port and the Computer In port. *5 This port is used for batch setup to copy menu settings. *6 USB 2.0 is supported. USB ports are not guaranteed to operate all USB devices. *7 Up to 900 mA when supplying power. *8 Connect a USB flash drive to this port to save the projector's operation logs.
HDMI/DVI-D interface board (ELPIF01) This is connected to Slot 1 at the time of purchase. No. Name A DVI-D In port (DVI-D 24-pin) B HDMI In port (HDMI Type-A) *1 C DC Out port (USB Type-A) *2 *1 HDCP 2.2 is supported. *2 Dedicated power supply port (up to 500 mA). USB ports are not guaranteed to operate all USB devices. 12 No. Name No. Name A Slot1 H Cable holder B Slot2 I RS-232C port (Mini D-Sub 9-pin male) C HDBaseT port (RJ45)*1 *2 J Remote port (Stereo mini pin jack) D LAN port (RJ45:
100BASE-TX/10BASE-T)*2 *3 K SDI Out port (1BNC female) E Computer In port (Mini D-Sub 15-pin female blue) L SDI In port (1BNC female) F Computer/BNC Out port (Mini D-Sub 15-pin female black)*4 M Service port (USB Type-B)*5 *6 G BNC In port (5BNC female) N USB-A port (USB Type-A)*5 *6 *7 *8