G etting S tarted > U nit O verview Installing the Batteries The GPSMAP 60CSx operates on two AA batteries (not included), which are located in the back of the unit. You can use Alkaline or NiMH batteries. See page 67 to set the battery type. Note: Lithium batteries are not recommended because the initial voltage of new batteries may exceed 1.5 volts each, which may cause the GPSMAP 60CSx to turn off. To install the Lanyard: 1. Place the loop of the Lanyard through the slot To install the batteries: 1. Remove the battery cover by turning the D-Ring 1/4 turn counter- clockwise and pulling the cover loose. 2 Route the strap through the loop and pull tight.
at the at the upper left side of the unit. 2. Insert the batteries, observing the proper polarity. A polarity diagram is molded into the battery compartment. USE BY 2009 USE BY 2009 USE BY 2009 USE BY 2009 Wrist Strap Installation 3. Reinstall the battery cover by aligning the back cover with the unit and turning the D-Ring 1/4 turn clockwise. Remove the batteries from your GPSMAP 60CSx when you do not expect to use the unit for several months. Data is not lost when batteries are removed. Battery Compartment Battery Compartment Refer to page 9 for information on accessing the microSD data card in the battery compartment. 2 GPSMAP 60CSx Owner’s Manual