Installation Remove Protective Coverings Place Charging Dock Against Wall and Charge Before using the vacuum-mop, remove the protective strips from both sides. · Place the charging dock near an electrical outlet in an area with a good Wi-Fi signal. · Tidy up loose cord as shown in the figure to prevent the vacuum-mop from getting tangled, which could accidentally move or unplug the charging dock. · Place the vacuum-mop onto the charging dock. The vacuum-mop will automatically turn on and begin charging. · After 10 minutes of the full charge of the battery, the indicator goes off. Install the Side Brush Insert the side brush into the attachment slot on the bottom of the vacuum- mop.
> 0.5 m > 0.5 m Tidy up Any Loose Cord Side Brush Clip Notes: · Fully charge the vacuum-mop before using it for the first time. · The vacuum-mop will remain on while connected to the charging dock. · When the vacuum-mop is left at the dock, it will consume a small amount of electricity to 9 allow the battery to maintain optimal performance in sleep mode. > 1.5 m