Safety Precautions To reduce the risk of fire, electrical shock, or injury to persons when using your air conditioner, follow basic precautions, including the following: WARNING - Prevent Accidents • Be sure the electrical service is adequate for the m odel you have chosen. This infor m ation can be found on the serial plate, which is located on the side of the cabinet and behind the grille. • If the air conditioner is to be installed in a window, you will probably want to clean both sides of the glass first. If the window is a triple-track type with a screen panel included, re m ove the screen co m pletely before installation.
• Be sure the air conditioner has been securely and correctly installed according to the installation instructions in this m anual. Save this m anual for possible future use in re m oving or installing this unit. • When handling the air conditioner, be careful to avoid cuts fro m sharp m etal fins on front and rear coils. Operation of Current Device Plug in & press RESET The power supply cord contains a current device that senses damage to the power cord. Test your power supply cord as follows: RESET 1. Plug in the air conditioner. 2. The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will notice a click as the RESET button pops out. TEST 3.
Press the RESET Button. You will notice a click as the button engages. 4. The power supply cord is now supplying electricity to the unit. (On some products this is also indicated by a light on the plug head.) NOTES • Do not use this device to turn the unit on or off. • Always m ake sure the RESET button is pushed in for correct operation. • The power supply m ust be replaced if it fails to reset when either the TEST button is pushed, or it can not be reset. Please contact Custo m er Service. • If power supply cord is da m aged, it can not be repaired. It MUST be replaced with a new cord. Please contact Custo m er Service. Page 7