BMW AG Motorcycle Division Maintenance schedule R 1100 S Order No. 01 71 7 654 263 UX-VS-2, 3.99 Printed in Germany Customer Licence plate No. Order No.
Mechanic’s signature BMW Inspection at 1,000 km (600 miles) BMW Service every 10,000 km (6,000 miles) BMW Inspection every 20,000 km (12,000 miles) BMW Annual Service Read out the fault memory with the BMW MoDiTeC unit Change the oil while at regular operating temperature and renew the oil filter element if motorcycle is used only for short journeys or at outside temperatures under 0°C, every 3 months, but at least every 3,000 km (1,800 miles) *) Change the oil in the gearbox while at regular operating temperature at least every 2 years every 2 years Change the oil in the rear wheel drive while at regular operating temperature Clean the inductive sensor at the rear wheel every 40,000 km (24,000 miles) or at least every 2 years *) 40,000 (24,000) every 2 years Renew fuel filter *) normally every 40,000 km (24,000 miles), if fuel quality is poor every 20,000 km (12,000 miles) 40,000 (24,000) Check battery acid level, if necessary add distilled water Clean/grease battery poles if necessary Renewing intake air cleaner element in very dusty or dirty operating conditions, renew the intake air cleaner element every 10,000 km (6,000 miles) or even more often if necessary *) Renew Poly-V belt *) Renew Poly-V belt every 60,000 km (36,000 miles); do not adjust 60,000 (36,000) Check brake fluid level at front/rear and top up if necessary *) Check operation of brake system and freedom from leaks; repair/renew items if necessary *) Examine brake pads and discs for wear, renew if necessary *) Renew the brake fluid annually Check clutch operating fluid level Change clutch fluid every 40,000 km (24,000 miles) or at least every 2 years *) 40,000 (24,000) every 2 years Check tightness of rear wheel studs Check rear wheel bearing play by tilting wheel Check swinging arm bearings (zero play); adjust if necessary *) Grease the side (prop) stand pivot Check function of side (prop) stand contact switch Check condition of spark plugs Renew spark plugs *) Take up slack at cylinder head nuts Check/adjust valve operating clearances Check throttle cable for free movement, abrasion and kinking; renew if necessary *) Check free travel in throttle cable Check synchronisation and eliminate any leaks *) Final inspection with road safety and functional check:
– condition of tyres and wheels, tyre pressures – lights and signalling equipment – telltale and warning lights – clutch, gear shift – handbrake and foot brake, steering – instruments – trial run if necessary *) Charged as an additional item