Generac Portable Products 2,100 PSI High Pressure Washer Use fresh, clean unleaded automotive gasoline and store in approved, clean, covered containers. Use clean fill funnels. Never use “stale” gasoline left over from last season or gasoline stored for long periods. Clean area around fuel fill cap, remove cap. Slowly add “UNLEADED” regular gasoline to fuel tank. Use a funnel to prevent spillage. Slowly fill tank to about 1/2” below the bottom of the filler neck (Figure 7). Figure 7 — Add Gasoline to Fuel Tank Attach the hose to the base of the spray gun (Figure 10). Tank 1/2” Air Space Fuel Install fuel cap and wipe up any spilled gasoline.
Before you connect your garden hose to the water inlet, inspect the inlet screen (Figure 11). Clean the screen if it contains debris, replace it if it is damaged. DO NOT RUN Connect Hose and Water Supply to Pump IMPORTANT: You must attach all hoses before you start the engine. Starting engine without all hoses connected and water supplied will damage the pump. NOTE: Your pressure washer comes with a quick connect that you can use to attach the high pressure hose to either the pump or spray gun. Uncoil the high pressure hose and attach the female quick connect to one end of the hose. Attach the male quick connect to the high pressure fitting on the pump (Figure 8).
Run water through the garden hose for 30 seconds to clean out any debris. Turn off water. IMPORTANT: Do Not siphon standing water for the water supply. Use ONLY cold water (less than 100°F). Connect the garden hose to the water inlet. Tighten by hand (Figure 11). Attach the other end of the high pressure hose to the high pressure outlet on the pump (Figure 9). Pull down on the collar of the quick connect, slide onto the pump and let go of collar. Pull on hose to be sure of a tight connection. CAUTION!
There MUST be at least ten feet of unrestricted garden hose between the pressure washer inlet and any flow shut off device, such as a ‘Y’ shut-off connector or other convenience-type water shut-off valve. Damage to pressure washer resulting from disregarding this caution will not be covered by the warranty. 7 Figure 9 — Connect High Pressure Hose to Water Outlet Figure 10 — Connect High Pressure Hose to Spray Gun Connect Hig Pressure Ho Here Figure 11 — Connect Gard en Hose to Water Inlet Inspect inlet screen. Do N use if damage clean if dirty. Figure 8 — Attach Quick Connect