How to Use 4. Pinch the clips, install the mop pad holder horizontally into the botom of the vacuum-mop, as illustrated. Turning On/Off When the vacuum-mop is on the charging dock, it will automatically turn on and cannot be turned off. To manually turn on the vacuum-mop, press and hold the buton until the indicator lights up. When the vacuum-mop is in standby mode and not on the charging dock, press and hold the buton to turn it off. Cleaning Turn the vacuum-mop on, then press the buton . Depending on the accessory installed, the vacuum-mop will automatically begin vacuuming or mopping. 5. Turn on the vacuum-mop. It is now ready to start vacuuming and mopping.
Recharging Turn the vacuum-mop on, then press the buton to send the vacuum-mop to the dock to recharge. When the vacuum-mop completes the cleaning task, it will automatically return to the dock for recharging, and the indicator is blinking yellow. If the vacuum-mop starts running low batery during a cleaning task, it will automatically return to the charging dock to recharge. Once the vacuum-mop is fully charged, it will resume cleanup where it lef off. If the vacuum-mop automatically shuts down due to low batery, manually place it onto the charging dock, and make sure the charging terminals have a good contact. Precautions: 1. Do not place the charging dock in an area with direct sunlight.
2. Make sure there are 0.5 meters or more of open space on either side of the charging dock and more than 1.5 meters in front. 3. If the vacuum-mop is unable to turn on due to low batery, place it directly onto the charging dock to recharge. 4. The vacuum-mop will automatically turn on when it is on the charging dock. 5. The vacuum-mop cannot be turned off when it is on the charging dock. 6. Remove the 2-in-1 dust compartment with water tank and mop pad holder when the vacuum-mop is charging or not in use. 7. Use the virtual wall or set restricted areas for carpeted areas to prevent the vacuum-mop from geting caught on the carpet. 8.
Regularly clean the dust compartment to prevent excess dirt accumulation. This can avoid reducing the cleaning performance of the vacuum-mop. 9. In cleanup mode, the vacuum-mop can do the cleaning with either the dust compartment or 2-in-1 dust compartment with water tank installed. Pausing While the vacuum-mop is running, press any buton to pause it, then press the buton to resume cleaning. Pressing the buton will end the current cleaning task and send the vacuum-mop back to the charging dock. 07