HOME 2.4 FRONT ENGINE MOUNT REPLACEMENT 11. Tighten all fasteners to 34-41 Nm (25-30 ft-lbs). 1. Support engine with a scissors jack under the oil pan. 12. Connect negative battery cable. Tighten to 6.8-10.8 Nm 2. Remove the right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 13. Reinstall air box cover. (60-96 in-lbs ). 3. Open seat. 14. Close seat. 4. Remove air box cover. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 15. Install maxi-fuse and right side cover. sm01766 5 To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 4 5. Disconnect negative battery cable. 3 6. See Figure 2-4 .
Loosen and remove nut (2) and travel limiting washer (1) from center mounting bolt (5). 2 1 7. Loosen and remove nuts (3) from engine mount bolts (4) (Left side requires using a 8 mm ball Allen with a 2 in. extension). 8. By lifting up the center mounting bolt (5) slightly, the engine mount pivots down and out away from the fan shroud. 1. Travel limiting washer 2. Center mounting bolt nut 3. Engine mount bolt nut 4. Engine mount bolt and washer 5. Center mounting bolt 9. Install new engine mount and left and right engine mounting bolts (4). 10. Install travel limiting washer (1) and center mounting bolt nut (2). Figure 2-4. Engine Mount (Exhaust Removed for Clarity) 2009 VRSC Service:
Chassis 2-11