No.20S025-02 8 Camera Functions This chapter describes the camera functions. 8.1 CXP Configuration This parameter sets the CoaXPress configuration mode. GenICam Parameters CXP configuration setting when power on camera CXP configuration setting can be save as “default CXP configuration” in to “UserSet data” to use default settings of power on camera. 1. Selects CXP configuration mode when power on camera. 2. Selects UserSet (0 to 7) at UserSetSelector. 3. Executes UserSetSave. 4. Selects UserSet (0 to 7), which is selected above “2.” at UserSetDefault. * The CXP configuration mode does not change when loading saved UserSet data using by “UserSetLoad”.
8.2 Pixel Format This parameter sets the image format from camera can be set on Pixel Format. GenICam Parameters The following chart shows available Pixel Formats on camera: The format specified on GenICam PFNC (Pixel Format Naming Convention). 8.3 Frame rate This parameter sets the frame rare (fps) of output image from camera. GenICam Parameters (*1) The approximate value of set value, sets to camera and display it. STC-MBS510CXP6 / STC-MCS510CXP6 Product Specifications and User’s Guide 25/49 CxpLink Configuration IEnumeration Type Sets CXP configuration mode. CXP6 X1: CXP-6 (6.250Gbps) 1lane (Default) _ CXP3 X1: CXP-3 (3.125Gbps) 1lane _ PixelFormat IEnumeration Type Sets Pixel Format.
Output Bit Pixel Format Monochrome Color 8bit Mono8 BayerRG8 10bit Mono10 BayerRG10 12bit Mono12 BayerRG12 AcquisitionFrameRate IFloat Type Sets frame rate in Hz unit (*1) Range is changed with exposure time and pixel format settings Default: 98.873442 (at CXP-6, 8bit)