No.20S025-02 8.13 Multi ROI The maximum eight ROI regions (one horizontal region x eight vertical regions) are configurable. Each region must not overlap other regions. Please set each region (Region0 to 7) from top of image to bottom of image and must not overlap other regions. The width of multi ROI sets at “Width” parameter. Same size of width applies for all regions. The total height of multi ROI sets at “Height” parameter. The frame rate can be increase when decreasing total image height (total of MultiHeight). The size of image width does not affect frame rate. GenICam Parameters *Note.1: (OffsetX + Width) and (OffsetY + Height) should not be smaller than maximum values. *Note.2:
The maximum frame rate will be change depending on setting of OffsetY when using same height of region. Three multiple regions: STC-MBS510CXP6 / STC-MCS510CXP6 Product Specifications and User’s Guide 34/49 MultiRegionSelector IEnumeration Type Selects the Multi Region of interest to control. Range: Region 0 to 7 Default: Region 0 MultiRegionMode [MultiRegionSelector] IBoolean Type Multi ROI function On / Off selection Off: Off (Default) On: On MultiHeight [MultiRegionSelector] IInteger Type Vertical lines of selected region of multi ROI Range: 4 to 2,048 lines, Default: 2,048 lines Setting steps:
2 lines MultiOffsetX [MultiRegionSelector] IInteger Type Horizontal offset of selected region of multi ROI Range: 0 to 2,192 pixels, Default: 0 pixels Setting steps: 2 pixels MultiOffsetY [MultiRegionSelector] IInteger Type Vertical offset of selected region of multi ROI Range: 0 to 2,044 lines, Default: 0 line Setting steps: 2 lines OffsetY0 OffsetX0 Width _ _ Region0 Height0 _ _ OffsetY1 OffsetX1 Width _ _ Region1 Height1 _ _ OffsetY2 OffsetX2 Width _ _ Region2 Height2 _ _ O ffsetY2 Region0 _ O ffsetY1 Region1 _ Height1 Region2 _ H