Iveco — Руководство по ремонту Iveco Trakker Euro 4/5 (EN)

220 F3B ENGINE T RAKKER E URO 4/5 PRINT603.93. 641  Figure 206 The exact position of piston no.1 when in the hole (3) in the flywheel (4). If this is not the case, turn and appropriately. Remove the tool 99360612 (1). 77259 cam l ift values of conditions: (3) in the engine Figure 207 Set the dial gauge with the magnetic (flat based) on the roller the injector of cylinder no.1 and 60575 NOTE During always be at right angles and NOT to the head illustrated in Figure 208 as follows: the gear (1) to the With tool 99360321 (6, Figure 205), clockwise until the pointer of the minimum value beyond which it (1) on the gear (2, as to bring about the Reset the dial gauge.

no t change at all; the check as described Turn the flywheel anticlockwise reading for the lift of the cam of the torque. mm. Base q November 2006 Print 603.93.641 71774 t the T.D.C. is obtained tions the tool 99360612 engine speed sensor into adjust the flywheel (4) 106535 c stand (1) with the rod rocker arm that governs e-load it by 6 mm. the dial gauge rod must o the engine centre line face. 05), turn the crankshaft dial gauge reaches the n no longer fall.

til the dial gauge gives a e camshaft of 5.33 0.05 Figure 208 The camshaft is in step if at th 5.33 0,05 mm there are the followin 1) a notch (5) can be seen through t 2) the tool 99360612 (1) through th speed sensor goes into the h flywheel (4). Figure 209 If you do not obtain the conditions il and described in points 1 and 2, proc 1) loosen the screws (2) securing camshaft and utilize the slots Figure 210); 2) turn the flywheel appropriately so conditions described in points 1 an understood that the cam lift mus 3) lock the screws (2) and repeat t above; 4) tighten the screws (2) to the req