Iveco — Руководство по ремонту Iveco Trakker Euro 4/5 (EN)

222 F3B ENGINE T RAKKER E URO 4/5  PRINT603.93. 641/A Adjust intake and exhaust rocker arm clearance, and pump injector preload Figure 213 60577 ADJUSTING INTAKE, EXHAUST AND INJECTION ROCKER ARMS The adjustment of the clearance bet ween the rocker arms and the crosspieces governing the intake and exhaust valves and the adjustment of the pre-load of the pump injector governing rocker arms has to be done very conscientiously. - With a suitable wrench (4), screw down the adjustment screw to take the pumping element to its limit. - Tighten the adjustment screw with a torque wrench to a torque of 5 Nm (0.5 kgm). - Unscrew the adjustment screw by 1/2 3/4 of a turn.

- Tighten the locking nut to a torque o f 39 Nm Take the cylinder whose clearance you want to adjust into the combustion phase. The valves of this cylinder are closed while they balance those of the symm etric cylinder. The symmetric correspondence of the cylinders is 1 - 6, 2 - 5 and 3 - 4. To perform these operations correctly, proceed as described below and as illustrated in the table. (3.9 kgm). Starting and FIRING SEQUENCE 1 - 4 - 2 - 6 - 3 - 5 Balance valves of cylinder no. Adjust clearance of Adjust pre-load of injectors of cylinder no. clockwise rotation valves of cylinder no.

Adjusting clearance between rocker arms and crosspieces governing the intake and exhaust valves - Using a box wrench, loosen the nut (1) locking the 1 and 6 at TDC 6 1 5 120є 3 4 1 120є 5 2 4 120є 1 6 2 120є 4 3 6 120є 2 5 3 adjustment screw. - Insert the strip of feeler gauge (3) corresponding to the working clearance (page 133); - Use a suitable wrench to screw or unscrew rocker arm (2) adjusting screw. - Check that the blade of the feeler gauge (3) can slide - Lock the nut (1) holding the adjustment screw still. with a light amount of friction.

NOTE To perform the above adjustments correctly, it is mandatory to follow the sequence given in the table, checking the position at each phase of rotation with the pin 99360612 to be inserted in hole identified by a notch on flywhe el, corresponding to TPD (see detail figure 190). Pre-load of pump injector governing rocker arms - Using a box wrench, loosen the nut locking the adjustment screw of the rocker arms (5) governing the pump injector (6). Base q November 2006 Print 603.93.641/A Revi - June 2007