Iveco — Руководство по ремонту Iveco Trakker Euro 4/5 (EN)

F3B ENGINE 223 T RAKKER E URO 4/5 PRINT603.93. 641  Figure 214 Fit the rocker cover (1). Fit the blow-by case (7) and screws (8) to the prescribed torque. Install the filter (5) and 60665 frame (3) and screwing up screws (2) at NOTE must be assembled with illustrated in the figure. up the following Fit the cover prescribed torque. NOTE Apply silicone LOCTITE fitted with P.T.O. described in the following pipes; and pipes; water and oil pipes; Figure 215 blow-by case and form a string water and lubricating oil to a in the figure. NOTE Fit the blow-by case (1) application. Print 603.93.641 Base q November 2006 85480 ket and then tighten the e. (4 and 6).

nidirectional, therefore it e two sight supports as stening screws (2) to the E 5970 (IVECO No. ase (7)surface of engines ding to the procedure figure. 85481 CO No. 2995644) on the of 1,5 , 0.5as shown 0.2 . within 10 from sealer Figure 216 Turn engine and mount oil rose pipe. Arrange gasket (4) on oil sump (1), p mount the sump on engine block scre prescribed torque: Completing Engine Assembly Complete the engine by fitting or hoo parts:

- power take-off (P.T.O., if present - fuel pump; - support complete with fuel filter - EDC central unit; - intake manifold; - preheating resistance; - heat exchanger; - oil filters, lubricating the gasket; - exhaust manifold; - turbocompressor and relating wa - pulley and damping flywheel; - thermostat assembly; - belt tensioner, water pump, alter - electromagnetic joint; - belt tensioner, if present, air-cond - starter; - oil level rod; - electrical connections and sensor NOTEThe fittings of the cooling w pipes of the turbocharger hav torque of: - 35 5 Nm, water pipe fittings; - 55 5 Nm, oil pipe female fitting; - 20-25 Nm, oil pipe male fitting.