Iveco — Руководство по ремонту Iveco Trakker Euro 4/5 (EN)

13 T RAKKER E URO 4/5 CLUTCH Print603. 93.641  Refitting PEDAL Unit removal-assembly Figure 19 (see Figure 20) Take out the springs (11) to return the pedals (13*-15). Eject the spring pins (7) so as to free the levers (1* and 2) from the pedals (13* and 15),which you should then extract from the pedal unit mount (18). To replace the roller bear- ings (9), use: - the percussion extractor 99340205 to remove them; - a suitable drift to fit them. 72838 For refitting, carry out the steps described for removal in re- verse order. Then adjust the travel of the pedals as described under the relevant heading.

NOTE The roller bearings and associated shafts have to be lubricated with TUTELA MR3 grease. Complete assembly by carrying out the steps per- formed for removal in reverse order. NOTE With each removal, the seals (1) of the coupling of thecontrol valvecover (2)havetobe replaced with new ones. Tighten the screws and nuts to the required torque. After re- fitting, check and if necessary adjust the travel of the pedal as described under the relevant heading. Figure 20 38808 1. Brake control lever q 2. Clutch co ntrol lever* - 3. Roller bearings q 4. Pin q 5. Fork q 6. Master cylinder* - 7. Spring pin q 8. Splitter control button* - 9. Roller bearings q 10. Washer q 11. Return spring q 12.

Pedal cover q 13. Clutch pedal q 14. Control valve q 15. Brake pedal q 16. Brake pedal limit stop screw q 17. Brake pedal stop bracket q 18. Pedal unit mount q 19. Clutch pedal stop bracket q 20. Clutch pedal limit stop screw* * Excluding vehicles with the EuroTronic gearbox. Base - November 2006 Print 603.93.641